Optimize mold design to avoid shrink mark

Properly increase section dimension of gate and runner; the position of gate is set at thick walls of the plastic parts and should be as symmetric as possible; improve mold exhausting condition; set cold-slug well with sufficient capacity to avoid cold material’s entering into the cavity and influencing filling and shrinkage compensation; […]

By |2020-07-12T14:56:01+08:00October 13th, 2015|Mirco Blog|0 Comments

Optimize injection technics to avoid shrink mark

Properly improve injection and dwell pressure as well as the injection rate to increase melt's compression tightness; prolong time of injection and dwell( the freezing of gate should not occur too early) to realize sufficient shrinkage compensation; properly reduce melt temperature and properly raise mold temperature( whereas cooling should be reinforce at parts with thick [...]

By |2024-09-27T18:18:18+08:00October 13th, 2015|Mirco Blog|3 Comments

plastic product design has more design options

please don't limite your design when you design a plastic part, because it Increases your design options and requirements and still keep costs down, and plastic is easy in producing complex shapes. you know, when we design a metal product, there are many many design limitations if we put several metal stampings or castings fastened [...]

Go to Top