Taking KBM to the Next Level in CAD/CAM system
An important factor of KBM(knowledge-based machining)is retaining the design knowledge and information already inherent in a CAD model and using that information’s power. […]
Use defined features in CAM systems
Feature-based CAM systems provide a standard set of machinable features using common shop terms such as slot, groove, pocket, hole, side or face. To further improve automation and machining productivity, […]
Knowledge-Based is Changing the Limits of CAM
KBM (knowledge-based machining (KBM)) can be incorporated into CAD/CAM systems at various levels. By comparing operations-based and process-based CAM systems to the automation capabilities offered by feature-based machining, there is a full range of capabilities afforded by KBM. […]
Introduction to Multi-Component Molding
Two, three or four component molding can work with automation just as easy as single component. Two types are manual transfer and rotating molds. Manual transfer requires the robot end-of-arm-tooling to remove the substrate from the first cavity, remove the finished parts from the second cavity and place the substrate into the second cavity (overmold). [...]
Introduction to Stack Mold Design
Parts are removed either from the top or side of the mold (usually determined by cycle time). Be aware of mold obstructions—such as stack mold linkages, hot runner control cables and connectors, cooling hoses, etc., […]
Introduction to Insert Molding
Insert loading is an easy process if the mold is designed properly. Try to keep the insert and removal sides of the mold opposite. Insert on the mold “A” half and part removal on the “B” half. This limits the mold open time, but requires more mold open dimension. Have generous lead-ins for the inserts, [...]
Introduction to Box Filling
Mold cavity layout and quantity can be designed to allow easier robotic box or fixture loading. If the shipping container or fixture is defined, design the mold with an even increment of that container. For example, a box holds 40 parts, […]
the difference between Hot Runner and Cold Runner
Molds with hot runner or valve gate systems will simplify end-of-arm-tooling (EOAT) design and reduce cost by eliminating runner grippers or vacuum cups and allow for faster part removal. If a mold must have a cold runner, […]
Introduction to a Solution of data exchange
A new software tool designed for the downstream user of the CAD model analyzes the data and highlights the problem areas – CADfixT. These problems may be corrected automatically in many instances or repaired manually. […]
What are the effectiveness of data exchange?
There are ways that the average user can directly impact data exchange effectiveness. Obviously, one area where you can influence the process is by becoming better informed and prepared. […]