There are five possible zones in a thermoplastic screw. Since terminology is not standardized in the industry, different names may refer to these zones. Different types of polymer will have differing screw designs, some not incorporating all of the possible zones.
Feed zone. Also called solids conveying. This zone feeds the resin into the extruder.
Melt zone. Also called the transition zone. The resin is melted in this section.
Pressurizing zone. Also called metering or melt conveying. This zone gives the plastic uniform pressure and flow characteristics.
Decompression zone. In this zone, the melt is unpressurized, allowing trapped gases (hydrochloride) to escape and be vented out.
Mixing zone. There are two types of mixing zone. They either distribute small particles evenly, or break large particles into small ones which can then be mixed.
Often screw length is referenced to its diameter in terms of an L:D ratio. For instance, a 6-inch (150 mm) diameter screw at 24:1 will be 144 inches (12 ft) long, and 192 inches (16 ft) at 32:1. In years past screw ratios of 24:1 were fairly common, but modern machines use 32:1, or higher ratios, which allow better mixing at higher throughput.
Each zone will be equipped with one or more thermocouples or RTDs for temperature control.
The screw is an essential component of a plastic extrusion machine. Through its turning motion inside a tight fitting barrel, the screw conveys the plastic, melts it and forces it through a die. These three steps are carried out in a continuous process capable of producing extrusions in a variety of lengths. The screw’s design is similar in principle to Archimedes’ screw of 250 BC, which was used to raise water to higher levels via axial rotation.
Modern engineering has expanded upon the screw of antiquity by redeveloping its geometry and applying it to plastic extrusion. Today’s extrusion screw can have varying pitch, helix angle, length to diameter ratio and length of processing stages. These variables influence the different pressure, shear and feed rates that are effective for a given plastic. Some extruders also use double screws to provide better additive mixing.
Thanks for sharing your experience on this issue, I got it, thanks!
I agree your opinion. good post!
thanks for your sharing
This piece of writing gives clear idea designed for the new people of blogging, that actually how to do blogging and site-building.
It’s going to be end of mine day, but before ending I am reading this wonderful piece of writing to increase my
know-how.
I am really delighted to read this web site posts which
consists of plenty of valuable facts, thanks for providing these statistics.
Thanks for every other magnificent article.
The place else may anybody get that type of information in such a perfect means of writing?
I have a presentation subsequent week, and I’m at the search
for such information.
Thanks very interesting blog!
It is perfect time to make some plans for the future and it’s time to be happy.
I’ve read this post and if I could I desire to suggest you few interesting things or advice.
Perhaps you could write next articles referring to this article.
I want to read even more things about it!