the fourth principle of designing ejector unit is in case the ejection position shall be on the base level of the plastic parts for use or assembly, the contact position of pin and the plastic parts shall be recessed 0.1 mm into the plastic parts to avoid the influence on the size and use of plastic parts, or else, the plastic parts would be upheaved and affect the smoothness of the base level.
your suggestion is very good
your suggestion is fine
your experience is very good, thanks for sharing
thank you for sharing your experience
Thank you very much for your guidance! I got it
this blog is very useful for some mold designers. thanks!
thanks for sharing your experience, I am a mold designer, I will do it like you do
Hi, I do believe this is an excellent web site. I stumbledupon it
;) I may come back yet again since I saved as a favorite it.
Money and freedom is the greatest way to change, may you be rich and continue to help others.
thanks for your comment! as for your question, maybe we could discuss it by Email.
Wobderful blog! I found it while searching on Yahoo News.
Do you have any suggestions on how to get listed in Yahoo
News? I’ve been tryung for a while but I never seem to get there!
Cheers