side core position in the core-pulling mechanism of a mold
The core should be set preferably in the moving or fixed mold vertical against the parting line so that the side core can be pulled out through mold opening or the pulling action.
Prevent mutual interference in the core-pulling mechanism of a mold
Try not to make the projection of the ejector pin coincide with that of the active core on the parting line to prevent mutual interference of the slide and the ejector unit during restoration.
the eighth principle for deciding on the parting line is to consider the impact of draft
the eighth principle for deciding on the parting line is to consider the impact of draft. […]
the seventh principle for deciding on the parting line is that parting line should be compatible with injection molding machine parameters
the seventh principle for deciding on the parting line is that parting line should be compatible with injection molding machine parameters. […]
the sixth principle for deciding on the parting line is to coordinate the lateral parting line and major parting line
the sixth principle for deciding on the parting line is to coordinate the lateral parting line and major parting line. If a plastic part with side holes or side slots, […]
the fifth principle for deciding on the parting line is easy to machining
the fifth principle for deciding on the parting line is easy to machining. For instance, a slanted parting line and a curved parting line, […]
the fourth principle for deciding on the parting line is to assure plastic part accuracy
the fourth principle for deciding on the parting line is to assure plastic part accuracy, for example, when we want to make a plastic gear in an injection mold, […]
the third principle for deciding on the parting line is to keep the plastic part on the side of moving half of it’s mold
the third principle for deciding on the parting line is to keep the plastic part on the side of moving half of it’s mold, […]
the second principle for deciding on the parting line is to facilitate venting
the second principle for deciding on the parting line is to facilitate venting. You know, the end of the material flow line is a good candidate for venting. For example, […]
decide parting line in your mold
when we start to design an injection mold for a plastic product, the first question is how to decide parting line. […]