At about 95 percent of the time, dampened adapters only fail due to tool crashes. Otherwise dampened tooling will last for many years of use. In fact, a lot of the systems manufactured in the 1980s are still in use today. […]
If your business has never used digital thermography, or if you’ve dabbled with it and weren’t satisfied with the results, or haven’t really kept up with the technology, it’s time to look again with a fresh set of eyes. […]
The rubber, plastics and wood panel industries work with heated tooling when material is pressed directly between hot platens. […]
The following are some of the mold safety issues that you will be addressing in developing this standard: 1) Mold Mounted Guards: In the event a mold has components that could be potentially hazardous when the machine’s operator gate is open or has components that extend beyond the guarding of the machine, guarding attached to [...]
Thermal Load StabilityOxidizing decay of organic components in thermal insulation boards increases with rising temperatures. Continuous thermal load is defined by the temperature at which the application of a particular grade can be technically and economically justified, so that the lifetime will extend to several years. […]
A number of recent EDM developments offer significant solutions to obstacles facing the moldmaking industry in the millennium. […]
The same general practices of machine tool maintenance, fixturing and rigidity of tool setup recommended for turning apply equally well for milling. Short tool extensions and properly adjusted machine tools are essential to good performance. […]
Most information for turning graphite applies to milling with inserted cutters. Disposable inserts with a 1/64″ or 1/32″ nose radius are most effectively employed for milling graphite. A positive rake insert is recommended. Cutting fluids and/or coolants are not recommended. Adequate and well-maintained fixturing, rigid tool set-up and well-adjusted machine tools always provide superior results. [...]
Disposable inserts with a 1/64- to 1/32-inch nose radius are most effectively employed for turning graphite. A positive rake insert without a chip control groove is preferred. Cutting fluids and/or coolants are not recommended. Adequate and well-maintained fixturing, rigid tool setup and well-adjusted machine tools always provide superior results. When machining long rods and cylinders, [...]
There does not seem to be a clear and reasonable distinction between moldmaking and mold repair. Applicants for in-house mold repair shops are quizzed about their moldmaking experience with the obligatory “Do you have any experience doing repair work?” question tagged on. […]