What is The Instrumented Mold?
As part of a rigorous mold tryout, it is essential to instrument a mold to see what is going on inside the mold. […]
Introduction to the process of Filling the Mold
With the proper temperatures set, the mold must be filled as fast as consistently possible. This means that the mold should be able to be filled to at least 90 percent of the injection rate of the production molding machine without adverse effects. […]
Understand Plastic Temperatures
It starts out with the temperatures of the plastic. The temperature of the plastic coming out of the molding machine should be right down the middle of the manufacturer’s spec. If you can run a mold here, […]
What is Mold Tryout?
How do you get a ready-to-go mold? Obviously, it starts with good design with no broken rules. It must be cut properly. It must be assembled properly. Checks must be made to ensure that all items function as designed, clearances are proper and water lines are correct based on flow. […]
What are the Integrated Hot Runner Systems?
The unitized system offers considerable improvements in quality and addresses the cost of repair favorably. Since the integrated system is based upon using the unitized prewired design for installation in the mold, the chance for pinched or severed heater and thermocouple wires is eliminated during assembly. […]
Introduction to Advantages of Unitized hot runner Systems
On unitized systems, the nozzles and manifold block constitute a single drop-in unit. The melt channel runs from the manifold block directly to the nozzle without any potential misalignment or dead spots. Any potential for plastic leakage between the nozzles and the manifold block is eliminated since the nozzles are inserted within the manifold by [...]
How to Choose plating
When choosing plating for your mold or mold components, you must first identify the problem to be solved or the problem to be prevented. The first question you should ask is “What is the cause of this problem? Is this problem the result of corrosion or wear?” If the component has previously been plated, this [...]
Introduction to Types of Plating
There are two basic types of plating – electrolytic and electroless. Electrolytic plating requires electricity to make the process occur. There is a positive and negative charge. The positive is called the anode and the negative is the cathode. The part to be plated gets the negative charge so it becomes the cathode. The anode [...]
Common Problems with Polishing Aluminum
The most common problem associated with polishing aluminum is the deep scratches that plague the finishes. Three things primarily cause deep scratches in aluminum: […]
Stoning to aluminium is the first step
The secret to getting a good diamond finish is to first have a fine scratch stone finish. The way to achieve this finish is to lighten up on the downward pressure as you stone . At first, you push down as hard as you need to in order to get rid of deep existing scratches, [...]