What are the advantages of laser engraving?
The advantages of laser engraving are described below: […]
Turning Graphite
Disposable inserts with a 1/64- to 1/32-inch nose radius are most effectively employed for turning graphite. A positive rake insert without a chip control groove is preferred. Cutting fluids and/or coolants are not recommended. Adequate and well-maintained fixturing, rigid tool setup and well-adjusted machine tools always provide superior results. […]
How to Milling Graphite with Inserted Cutters
Most information for turning graphite applies to milling with inserted cutters. Disposable inserts with a 1/64″ or 1/32″ nose radius are most effectively employed for milling graphite. A positive rake insert is recommended. Cutting fluids and/or coolants are not recommended. Adequate and well-maintained fixturing, rigid tool set-up and well-adjusted machine tools always provide superior results. [...]
How to Milling Graphite by End Mills
The same general practices of machine tool maintenance, fixturing and rigidity of tool setup recommended for turning apply equally well for milling. Short tool extensions and properly adjusted machine tools are essential to good performance. […]
decide the Level of participation in eletrode fabrication
There are many degrees of electrode fabrication,and a moldmaker’s first step is to decide what level of participation he or she wants to have. He poses the following questions: […]
How to start a new mold in oversea?
There are many benefits to moving your manufacturing to Asia, but before making a decision that could significantly affect your company’s bottom line, consider some of the factors that need close monitoring in order to avoid potential problems: the difference in communication and culture; the shipment of finished molds and parts as well as actual [...]
What are the Advantages of US molds?
A clear advantage a U.S. mold builder has is the ability to ‘service what you sell’. Consider the differences between a U.S. mold builder who produces 50 tools per year to an overseas manufacturer who produces 500 tools per year. Each is vying for a role with a tooling engineer for a 10-mold program. The [...]
How to understand US molds
Contrary to some perceptions, U.S. mold builders still have a lot going for them. Granted, the going has gotten tougher over the past 10 years, but it’s not as though a shop owner is stuck owning a buggy whip store in an automotive era. There are many areas in which to compete and serve mold [...]
Introduce Leasing Options to someone of leasing equipment
Leasing new or used equipment for up to $75,000 usually involves completing a one-page application. In most cases, a decision on the lease is made within 24 hours, but some decisions are made in as little as eight hours. Documents are sent to the buyer (lessee), signed, and then returned to the funding source (lessor). [...]
Coatings of cutting tool are important to tool life
The nature of HSM generates less heat when compared to conventional machining, but the temperatures in the cut also are more constant. Therefore, more advanced physical vapor deposition (PVD) coatings are needed to sustain the cutting edge while it is engaged in the material. […]